How do i "busy out" a dial peer to generate an Alert
We need to simulate a dial-peer "busy out" scenario to generate an Alert in our Lab environment.
In order to simulate the same we have tweaked the target ip in the dial-peer to a dummy ip. However , when we check the dial-peer summary output the dial-peer status still shows as "Up" . The "sip options keep alive" is also present in the dial-peer config. Are we missing something here in the method we are following to simulate the "busy out" scenario for the dial-peer?
Can someone shed some light on how we could achive the same?
Is there a way in UCCE with using an admin script maybe using the email application in Call Studio to send out an email? I know in UCCX you can send out an email if the script were to fail but is there a way to do it in UCCE? Any help would be great!
Fun lab with Packet Tracer and running Cisco CME with 3 ip phones, 3 laptops, 1 switch, and 1 router. Fun lab with repetition. You will be able to test your phones and laptop for connectivity etc. Solution;see attached CME Packet Tracer L...
How to configure IP Address for Cisco Integrated Management Controller CIMC. The Cisco Unified Computing System (UCS) is a data center product composed of computing hardware, virtualization support, switching fabric, and management software.
QuestionHi Team,I just need to confirm if we change NTP servers on UCCX, will it affect the license on UCCX 12.0 ?Do we need to re-host after updating NTP?Already done on CUCM and CUC , and it didn't affect but not sure for CCX. Thank you ...