08-08-2012 10:32 AM - edited 03-16-2019 12:37 PM
Hello everyone, I wondering if someone knows a command on VG to know if some device is connected to the voice port.
When I put this command:
VG202#sh stcapp dev sum
Total Devices: 2
Total Calls in Progress: 1
Total Call Legs in Use: 1
Port Device Device Call Dev Directory Dev
Identifier Name State State Type Number Cntl
---------- --------------- -------- ------------- ------- ----------- ----
0/0 AN1FCAF21730000 IS IDLE ALG 5847 CCM
0/1 AN1FCAF21730001 IS RINGIN ALG 5833 CCM
This doesn't guaranteed that analog phone is ringing, because maybe the phone cord is unplugged.
thanks in advance
Alex
Solved! Go to Solution.
08-08-2012 03:08 PM
There is no way of knowing that.
08-08-2012 03:08 PM
There is no way of knowing that.
08-13-2012 06:21 AM
Thanks Paolo,
I even tried to compare 2 ports (one with phone hooked up) searching some difference in the output of command "show voice-port" but nothing.
Thanks again for your confirmation.
Alex
08-13-2012 06:43 AM
You're welcome, please remember to rate useful posts clicking on the stars below.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: