08-29-2016 05:00 AM - edited 03-17-2019 07:57 AM
Hi,
I have a CMBE6K-S preconfigured.
The problem is that the CUCM was configured with a timezone with Summer Time (Dst) enabled.
I want to remove the DST, so my timezone will be OK. I've already changed the NTP reference, or the Date/Time Group but no success.
When I check on the CLI I still see the dst and the original timezone where Cisco has preconfigured the CUCM.
We are in a region (emea) that not need the DST. (GMT+3 Nairobi).
how to do it?
Regards,
Antra
08-29-2016 05:25 AM
Refer below link to update/change DST
https://supportforums.cisco.com/discussion/11286791/cucm-timezone
http://www.cisco.com/c/en/us/support/docs/unified-communications/unified-communications-manager-callmanager/118744-technote-cucm-00.html
You can view the list of available time zones with this command:
admin:show timezone list
0 - Africa/Abidjan
1 - Africa/Accra
2 - Africa/Addis_Ababa
3 - Africa/Algiers
4 - Africa/Asmara
5 - Africa/Bamako[...]
405 - Europe/Warsaw
[...]
And time zones on CUCM can be set with this command:
admin:set timezone 405
Using timezone: Europe/Warsaw
A system restart is required
In this command, 405 is the mapping of the 405 to the Europe/Warsaw time zone.
04-11-2023 10:40 AM
I have the same problem
Refer below link,
it helps me a lot though
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/rel_notes/10_5_1/CUCM_BK_CE15D2A0_00_cucm-release-notes-1051/CUCM_BK_CE15D2A0_00_cucm-release-notes-1051_chapter_01.html#CUCM_RF_D5EC2022_00
I still can't find a solution,
Regards,
Luis
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: