How to DSCP mark RTP / RTCP packets if RTP / RTCP ports are dynamically set?
I have layer 3 routing enabled on a Cisco 3750 switch and I have a Cisco 1921 router connecting to the public Internet.
Traffic from clients is first routed to the Cisco 3750 switch, and then out the 1921 router.
Where and how would I set DSCP markings on RTP and RTCP packets if those ports are dynamically allocated? I'm assuming on the router since it probably has some type of RTP / RTCP inspection that I can use? I think I have half the equation here, just hope that someone can help take me the rest of the way.
Re: How to DSCP mark RTP / RTCP packets if RTP / RTCP ports are dynamically set?
You can set them on the switch using two ways:
1. Either you trust the marking from the phone on the switch using the option cisco-phone to make sure that trust is limited to cisco phones. Phones will mark the packets using the configuration from CUCM 2. configure an ACL on the switch to match voice subnets and rtp/rtcp port range and set the dscp value on the switch as well.
This document is intended to receive any new ideas for TAC to create new useful walkthrough videos to help set up deployments, integrations, etc.
Feel free to share any feedback about new walkthrough videos you consider useful, please share your o...
Configuring Cloud Connected PSTN (CCP) – Easy as 1-2-3!
STEP 1: PREPARE
Before you can configure your CCP in Control Hub, you must procure PSTN services from an authorized Webex Calling CCP Partn...
To participate in this event, please use the button to ask your questions
This topic is a chance to discuss more about how to read Cisco Unified Communications trace files. In this session, Cisco D...