05-10-2016 08:34 PM - last edited on 03-25-2019 08:39 PM by ciscomoderator
Good day,
Is a way to determine if FXO ports are empty? I have a router in a remote location and want to find out which ports have an RJ-11 connection and which ones are empty.
Regards
05-10-2016 08:38 PM
Hi Rahul,
Check these posts
https://supportforums.cisco.com/discussion/12922566/fxofxs-port-status-connected-or-not
https://supportforums.cisco.com/discussion/10641656/fxo-finding-if-line-plugged
Manish
05-18-2016 06:41 PM
Thanks for your suggestions. Also is there a hunt scheme that can choose only ports that have rj-11 plugged in or to use a hunt scheme to select specific ports for outgoing calls?
05-15-2016 05:24 AM
you can use command below
test voice port x/y/z si-reg-read 29 1
if there is value so ports have an RJ-11 connection if not so port have no RJ-11 or there is a problem indirection of PSTN .
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide