cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
258
Views
0
Helpful
1
Replies
Beginner

How to see ringbacktone with debugs

I want to see if the ringbacktone is send to the pri line [connects to a pbx] in SIP calls. Which debug I should use? The call is starting from the pbx and goes to the IP. But they dont hear ringbacktones. You can see the configuration below.

voice call send-alert

dial-peer voice 1 voip

progress_ind setup enable 3

progress_ind alert enable 8

progress_ind progress enable 8

progress_ind connect enable 8

rtp payload-type nte 99

session protocol sipv2

session target ipv4:x.x.x.x

dtmf-relay rtp-nte

no vad

Thanks.

1 REPLY 1
Highlighted
Cisco Employee

How to see ringbacktone with debugs

Hi,

The debug voice ccapi inout should help you with that

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards