hunt group

[juancarlosmartinez]

Hi All

How can I configure a peer hunt group so when a incoming call happen the call  go to the main ext then if is busy  or no answer can  ring to the 2nd extension if is no answer  go to the 3rd ext, then voice mail.

I am using call manager express.....

is 3 extensions......

thanks guys

[paolo bevilacqua]

Wrong forum. post in "IP telephony". You can move your post using the actions panel on the right.

[juancarlosmartinez]

Thanks Paolo

[kaja_2kj3 · Accepted solution]

Hi

I think you can choose in between peer hunt group or sequential hunt group,

    Peer Hunt Groups

In a peer hunt group, extensions ring in a round-robin order. The first extension to ring is the number in the list to the right of the last extension to ring when the pilot number was last called. Ringing proceeds in a circular manner, left to right, for the number of hops specified when the hunt group was defined.

ephone-hunt 1 peer

pilot 5601

list 5001,5002,5017,5044

final 6000

hops 3

preference 1

timeout 30

no-reg

    Sequential Hunt Groups

In a sequential hunt group, extensions always ring in the order in which they are listed, left to right, when the hunt group is defined. The first number in the list is always the first number to be tried when the pilot number is called. Maximum number of hops is not a configurable parameter for sequential hunt groups.

ephone-hunt 1 sequential

pilot 5601

list 5001,5002,50017

final 6000

preference 1

timeout 30

for more information, please see the link below.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmecover.html#wp1171438

Please rate if this helps, by clicking the stars below.

Thanks