cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays
1164
Views
0
Helpful
2
Replies
fuhrersk8
Participant

Hunt Pilot incoming call from PSTN gets disconnected in CUCM 8.5

                   Hello guys!

When a PSTN phone calls into a configured hunt pilot in CUCM 8.5, the internal phones ring as configured (broadcast) but if no one answers the call gets disconnected after three rings. Please help and thanks in advanced. 

1 ACCEPTED SOLUTION

Accepted Solutions

Hi,

what have you configured as your cfwd noan on your hunt pilot? If you have not configured anything, then i dont see a problem. The call cant ring forever. It will ring the destination based on your configured timer. Have a look here at how to configure hunt pilot settings..

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_5_1/ccmcfg/b03htpil.html#wp1068675

Please rate all useful posts

View solution in original post

2 REPLIES 2

Hi,

what have you configured as your cfwd noan on your hunt pilot? If you have not configured anything, then i dont see a problem. The call cant ring forever. It will ring the destination based on your configured timer. Have a look here at how to configure hunt pilot settings..

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_5_1/ccmcfg/b03htpil.html#wp1068675

Please rate all useful posts

View solution in original post

Thanks for the reply. It is the RNA Timeout value. Thanks again!

Content for Community-Ad

Spotlight Awards 2021