Hi guys!
I have an VG320 with this config on port 0/1/23:
voice-port 0/1/23
cptone ES
timeouts initial 60
timeouts interdigit 60
timeouts call-disconnect 1
timeouts ringing infinity
timeouts wait-release 1
timing hookflash-in 50 0
caller-id enable
Foreign Exchange Station 0/1/23 Slot is 0, Sub-unit is 1, Port is 23
Type of VoicePort is FXS ON-BOARD-24FXS version 0xC3
Operation State is DORMANT
Administrative State is UP
No Interface Down Failure
Description is not set
Noise Regeneration is enabled
Non Linear Processing is enabled
Non Linear Mute is disabled
Non Linear Threshold is -21 dB
Music On Hold Threshold is Set to -38 dBm
In Gain is Set to 0 dB
Out Attenuation is Set to 3 dB
Echo Cancellation is enabled
Echo Cancellation NLP mute is disabled
Echo Cancellation NLP threshold is -21 dB
Echo Cancel Coverage is set to 128 ms
Echo Cancel worst case ERL is set to 6 dB
Playout-delay Mode is set to adaptive
Playout-delay Nominal is set to 60 ms
Playout-delay Maximum is set to 1000 ms
Playout-delay Minimum mode is set to default, value 40 ms
Playout-delay Fax is set to 300 ms
Connection Mode is normal
Connection Number is not set
Initial Time Out is set to 60 s
Interdigit Time Out is set to 60 s
Call Disconnect Time Out is set to 1 s
Supervisory Disconnect Time Out is set to 750 ms
Ringing Time Out is set to infinity
Wait Release Time Out is set to 1 s
Companding Type is u-law
Region Tone is set for ES
Analog Info Follows:
Currently processing none
Maintenance Mode Set to None (not in mtc mode)
Number of signaling protocol errors are 0
Impedance is set to 600r Ohm
Station name None, Station number None
Caller ID Info Follows:
Standard ETSI
Output attenuation is set to 14 dB
Caller ID is transmitted after 1 ring(s)
Translation profile (Incoming):
Translation profile (Outgoing):
lpcor (Incoming):
lpcor (Outgoing):
Voice card specific Info Follows:
Signal Type is loopStart
Ring Frequency is 25 Hz
Hook Status is On Hook
Ring Active Status is inactive
Ring Ground Status is inactive
Tip Ground Status is active
Digit Duration Timing is set to 100 ms
InterDigit Duration Timing is set to 100 ms
Hookflash-in Timing is set to max=1000 ms, min=150 ms --> timing hookflash-in 50
Hookflash-out Timing is set to 400 ms
No disconnect acknowledge
Ring Cadence is defined by CPTone Selection
Ring Cadence are [15 30] * 100 msec
Ringer Equivalence Number is set to 1
The port is "onhook_pend" during 40 seg!!! I need a time of 50ms. I suppose that I need the command: "timing hookflash-output 50"... but in VG320 (IOS 15.6(3)M1) this command not appers:
VG320(config-voiceport)#timing ?
digit DTMF digit duration in milliseconds
hookflash-in Hookflash input duration in milliseconds
inter-digit DTMF inter-digit duration in milliseconds
PLEASE: ANY IDEA!?
THANKS IN ADVANCE!