01-21-2015 11:26 AM - edited 03-17-2019 01:40 AM
I recently purchased a MX700, so I have a question, I can connect a projector?
01-22-2015 11:47 AM
Yes, the MX700 supports one additional video output. You should be using TC7.3.0 or later on the MX700 to enable this. The projector needs to be able to synch to one of the output resolutions / frequencies that are listed on the MX700 Datasheet. In particular, the projector needs to be able to support a 16:9 screen format using either 720p or 1080p at a frame rate of either 50Hz or 60 Hz.
08-23-2017 10:09 AM
if I have a MX700 Dual 55-inch Screens (CTS-MX700D-2CAM-K9), I can connect a projector?
08-23-2017 09:56 PM
See Enrico's reply above, the MX700 supports 3 video outputs: 2 HDMI and 1 DVI-I. You can connect an external monitor or projector to any one of the free outputs.
08-24-2017 06:55 AM
but, do MX700 used 2 HDMI to the 2 display 55¨, only do it have 1 DVI-I to the proyect?
08-24-2017 09:05 AM
Yes, the MX700 uses HDMI 1 and HDMI 2 for the 55 inch screens. This leaves you with DVI 3 output to take to the projector. DVI 3 supports either VGA or DVI-D - in other words, an analog video signal or a digital video signal. If the projector supports HDMI, then you should run a DVI to HDMI cable to the projector.
08-24-2017 02:03 AM
the below image shows that you can insert 3 displays to the SX80 or MX700 & MX800 codec .. 2 HDMI and 1 DVI ..
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide