cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

AMA-CUCM Troubleshooting: Best Practices for Reading Trace Files

2851
Views
0
Helpful
18
Replies

I had the same issue, and

I had the same issue, and fixed it using the following procedures

- Remove the cluster domain and fqdn on service parameters in both sites;

- Cancel the registration in the spoke cluster

- Saved the spoke cluster again, with the hub Publisher IP;

- Restarted ILS service

- Wait the synchronize time.

Engager

HILook i just tested on same

HI

Look i just tested on same version , it was working without any issues.Can you try to make it again :just change the "password" and select HUB after save kindly check that HUB configuration overwrite standalone , and same for Spoke. Check also the SIP trunk between the both clusters "on the sip trunk destination ".Restart service intercluster look up helped me to solve same issue for one of my customers.

Thanks

Hi,Thanks for tyour promt

Hi,

Thanks for tyour promt answer:

1. Yes my intention is to use URI dialing.

 

2. The registration seems to be successful. There is no "Cancel" button anymore. I can change Spoke back to Stanalone cluster. Then change it back to Spoke and enter the IP of the hub as the registration server. I have already doen it before.

3. I have just restarted ILS service on Hub and Spoke. Did not change anything.

Regards

 

 

 

 

 

Beginner

Hello

Hello

try this solution:

ON YOUR HQ site:

for each user on End user, specify his uri dialing: like hquser1@cisco.com

 Associate each ip phone with his user (owner id), do same on DN

Create Sip profile by coping the standard, named URI-SIP-PROFILE, on it

check "Use Qualified Domain Name in SIP Request"

Create CSS named URI-CSS and add partition uri directory on it

on CSS of DN user choose URI-CSS

Create SIP Trunk named URI-TRUNK, choose URI-SIP-PROFILE

in inbound call CSS choose URI-CSS

Create SIP Route Pattern to you br like: br.route, choose URI-TRUNK

on Intercluster Directory URI Configuration, check Exchange Direct. uri and on

Route string: hq.route

Go to ILS configuration, choose Hub Cluster, set password (be carfull must same on Br)

click on save, set nothing on ip registration, click ok

ON YOUR BR site:

for each user on End user, specify his uri dialing: like bruser1@cisco.com

 Associate each ip phone with his user (owner id), do same on DN

Create Sip profile by coping the standard, named URI-SIP-PROFILE, on it

check "Use Qualified Domain Name in SIP Request"

Create CSS named URI-CSS and add partition uri directory on it

on CSS on each DN choose URI-CSS

Create SIP Trunk named URI-TRUNK, choose URI-SIP-PROFILE

in inbound call CSS choose URI-CSS

Create SIP Route Pattern to you hq like: hq.route, choose URI-TRUNK

on Intercluster Directory URI Configuration, check Exchange Direct. uri and on

Route string: br.route

Go to ILS configuration, choose Spoke Cluster, set password (be carefull must same on hq)

click on save, set ip address of QH publisher, click ok

after 2 minutes click on Refresh, You ILS successfully registered!!! 

Try dialing URI,

it will work fine:)

 

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards