01-09-2018 08:34 PM - edited 03-17-2019 11:54 AM
Hello Everyone,
I hope, everybody enjoyed their beautiful vacation after "Christmas and New Year" of course with new wishes and target for 2018.
I wish the same to everyone to achieve it,but to get that need to do hard work, hard study and hard troubleshooting, that's it.
I have location where we will deploy "Skype for business " and same time we will have exist setup of CUCM. I have been informed my superior about that and saying that we will remove CISCO Voice Gateway and will deploy "Audio Code" as gateway which will integrated with CISCO CUCM (Via Trunk link) and SFB so for me it quite challenge to do this, i would be responsible for CISCO only but i need to ensure the business should not hamper so need your expertise on this.
1 ) What major changes required during this activity on CUCM?
2) What precaution i need to take to accomplish this task?
3) Anything best way to do this.
" The prompt response would be highly appreciated"
Regards
Viru
Solved! Go to Solution.
01-16-2018 06:36 AM
Hi,
This is a forum, so people might not know the answer. There is no guarantee that you will get an answer.
Anyway:
Seems you want to use an audiocode gateway for CUCM and SFB. So from CUCM side you configure a SIP trunk pointing to the audiocode and make sure the audiocode is configured correctly (don't know audiocode)
You ask:
What major changes required during this activity on CUCM?
// You have to configure a SIP trunk on CUCM
What precaution i need to take to accomplish this task?
// Not sure what you mean, but configuring a SIP trunk is not that complicated
Anything best way to do this.
// Again not sure what you mean, still configuring a SIP trunk
Regards
JH
01-15-2018 11:08 PM
Hello All,
Did i ask anything wrong, till no answer on this query very surprise.
Regards
Viru
01-16-2018 06:36 AM
Hi,
This is a forum, so people might not know the answer. There is no guarantee that you will get an answer.
Anyway:
Seems you want to use an audiocode gateway for CUCM and SFB. So from CUCM side you configure a SIP trunk pointing to the audiocode and make sure the audiocode is configured correctly (don't know audiocode)
You ask:
What major changes required during this activity on CUCM?
// You have to configure a SIP trunk on CUCM
What precaution i need to take to accomplish this task?
// Not sure what you mean, but configuring a SIP trunk is not that complicated
Anything best way to do this.
// Again not sure what you mean, still configuring a SIP trunk
Regards
JH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide