Inbound call issue.Cause i = 0x809C - Invalid number format (inc
++ In the above setup message, there was no called number, so wondering how the receiving end will route the call. And that explains the error message too. Can you check with them why they are not sending the called number in the setup.
// Below setup only has calling number, no called number.
Sending Complete Bearer Capability i = 0x8090A3 Standard = CCITT Transfer Capability = Speech Transfer Mode = Circuit Transfer Rate = 64 kbit/s Channel ID i = 0xA9839B Exclusive, Channel 27 Calling Party Number i = 0x0083, '55491715' Plan:Unknown, Type:Unknown
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...