Hey all.
I'm trying to finish up configuration on a Cisco 2901 voice gateway connected to a few POTS lines.
Outbound dialing works fine, I see the calls hit the router and they go out just fine. However, for inbound calls, they ring a few times and then go fast busy, and I see this:
2901#sh call active voice compact
<callID> A/O FAX T<sec> Codec type Peer Address IP R<ip>:<udp>
Total call-legs: 1
100 ANS T0 None TELE P
They hit the router but the router doesn't seem to send them anywhere. I've attached my voice gateway configuration as well as my debug voice ccapi all logs.
