i have a Cisco router acting as a voice gateway with two ISDN connection: 1)E1 connection that is to be used for all calls "inbound/outbound" 2)SIP trunk connection to the TELECOM just for incoming calls to specific extension "DN" . My CUCM is connected to my gateway using H.323. My E1 connection is work fine but my incoming sip calls does not working properly.
for the incoming calls on sip, I am getting no ring back. The call flow is as follows:
PSTN-->SIP Line-->GW-->H.323-->CUCM -->Translate to extention "DN"-->extension rings but from the PSTN side no ring back is heard.
please help me and tell me what should i do to solve this issue?
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...