cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

1411
Views
0
Helpful
4
Replies
Highlighted
Beginner

Installing an analog polycom soundstation 2 on FXS port in CUCME

I apologize if this is a stupid question, I'm an Avaya voice (cisco data) guy, I'm still learning Cisco voice.

I've installed an analog polycom soundstation 2, I can make internal and external calls.  However I can only receive one incoming call at at time (second call receives a busy signal) and I can't conference a second call.

From researching I think I need to change the FXS port from MGCP to SCCP (I have the license for it) but I'm not 100% sure that's correct and if it is I'm not sure how to do it.

Any advice would be much appreciated.

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Enthusiast

Installing an analog polycom soundstation 2 on FXS port in CUCME

For a FXS port with an analog phone attached to it, you may want to use SCCP:

SCCP Controlled Analog (FXS) Ports with Supplementary Features in Cisco IOS Gateways

http://www.cisco.com/en/US/docs/ios/12_4t/12_4t2/ht1vg224.html

HTH

--
Jorge Armijo

Please remember to rate helpful responses and identify helpful or correct answers.

-- Jorge Armijo Please remember to rate helpful responses and identify helpful or correct answers.

View solution in original post

4 REPLIES 4
Highlighted
Enthusiast

Installing an analog polycom soundstation 2 on FXS port in CUCME

For a FXS port with an analog phone attached to it, you may want to use SCCP:

SCCP Controlled Analog (FXS) Ports with Supplementary Features in Cisco IOS Gateways

http://www.cisco.com/en/US/docs/ios/12_4t/12_4t2/ht1vg224.html

HTH

--
Jorge Armijo

Please remember to rate helpful responses and identify helpful or correct answers.

-- Jorge Armijo Please remember to rate helpful responses and identify helpful or correct answers.

View solution in original post

Highlighted
Beginner

Installing an analog polycom soundstation 2 on FXS port in CUCME

Thank you for your quick response, I will without a doubt need the information in the link you provided.  Is there any information you can provide that will instruct me on how to change the port to SCCP?

Highlighted
Enthusiast

Installing an analog polycom soundstation 2 on FXS port in CUCME

This should give you an idea where to start

http://www.icciev.com/1/post/2011/09/adding-vg224-to-cucm-80-as-sccp-or-mgcp-gateway-differences-and-configurations-part-2.html

--
Jorge Armijo

Please remember to rate helpful responses and identify helpful or correct answers.

-- Jorge Armijo Please remember to rate helpful responses and identify helpful or correct answers.
Highlighted
Beginner

Installing an analog polycom soundstation 2 on FXS port in CUCME

I opened a support case on this issue and they gave me the same information Jorge did.  It would have worked if the customer had the DSP resources available.  Never thought an analog phone would be such a pain.  Ended up setting up a 7937 conference phone.

Thanks for you help.

CreatePlease to create content
Content for Community-Ad

Cisco COVID-19 Survey