We have an Axis A8105-E and CUCM12.5 and trying to get the Axis Doorbell to work. So far I have followed the following guide found here.
We ended up creating a new Region and Device Pool and associated the Device with Device Pool. The region required a max session bit rate for Video calls to 2048. We are now getting Audio and Video on our Cisco Phones 8845 and 8865. However, we are unable to get DTMF tones to pass to open the door. Has anyone has success with integrating Axis A8105-E and CUCM?
Yes I did. Under the doorbell I had to go under VOIP>SIP Settings>DTMF payload type and changed from 96 to 101. This number I believe is set under the SIP Profile on the SIP Phone you created in CUCM.
Let me know if you have any other questions.