05-13-2015 11:59 AM - last edited on 03-25-2019 08:35 PM by ciscomoderator
Hi Team,
We have implemented time schedule configuration in CUCM 10.X. Now its working as Time-of-day routing routes calls of office hours all PSTN incoming & outgoing calls and internal 4 digit CUG-calls also working.
Now after office (NON Business) hours all PSTN outgoing calls are blocked, but the same time internal 4-digit also blocked.(unable to reach extension to extension)
My requirement is internal four digit calls (Extension to extension) need to be work and outgoing calls to be block on non-business hours.
We have configured below step:
Step 1. Create Time Periods
Step 2. Create Time Schedule
Step 3. Assign Time Schedules to Partitions
Step 4. Create a Calling Search Space
Step 5. Configure Translation Pattern
CUCM version 10.X
Please help..
Thanks & Regards,
Johnson
Solved! Go to Solution.
05-13-2015 12:55 PM
ToD logic and configuration has been covered in plenty of threads before, have you reviewed any of them????
Simply put:
You need two partitions, same numbers, depending on whether they're active, they will be listed in the CSS of devices, or not. That's what makes ToD work, most likely you used the partition for all DNs there, and not created a new one, just for ToD purposes.
05-13-2015 12:55 PM
ToD logic and configuration has been covered in plenty of threads before, have you reviewed any of them????
Simply put:
You need two partitions, same numbers, depending on whether they're active, they will be listed in the CSS of devices, or not. That's what makes ToD work, most likely you used the partition for all DNs there, and not created a new one, just for ToD purposes.
05-13-2015 09:47 PM
Hi Jaime,
Thanks for update.
But I have single line phones are using Cisco 3905.
regards,
Johnson.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide