cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
236
Views
0
Helpful
2
Replies

IP Phone 7940g - "Phone provisioning"

Dear All,

 

I hav tried to upgrade firmware from SCCP to SIP (non supported CUCM) in my 7940g. First i have done factory restored the device and tried to uplode the SIP firmware to it by using tftpd32. IP is assigned to my deivce from tftpd32 DHCP and then i was in the state "Phone Provisioning". Can anybody please help me on this iisue.

 

Regards,

Chaitanya

2 Replies 2

manpreetsingh46
Level 1
Level 1

Hi Chaitnya,

 

best way to troubleshoot this is to get the pcaps from the phone. we can use the span to PC option of the Phone or we can span the switchport, to which the phone is connected so that we can see the file its is requesting and to which server it is requesting.

 

Please check this link also if you have followed all the steps for this.

 

http://www.cisco.com/c/en/us/support/docs/collaboration-endpoints/unified-ip-phone-7900-series/5455-handset-to-sip.html

Hi Manpreet,

 

i have seen these messages in my tftp server log viewer. Please check once below.

 

Connection received from 192.168.1.1 on port 50643 [31/03 19:52:54.691]
Read request for file <SIP001E7A26BBD5.cnf>. Mode octet [31/03 19:52:54.691]
File <SIP001E7A26BBD5.cnf> : error 2 in system call CreateFile The system cannot find the file specified. [31/03 19:52:54.691]

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: