09-02-2015 08:59 AM - edited 03-17-2019 04:11 AM
Hi guys
We are going to deploy dot1x access with LSC certificate for our IP Phones and since we are talking about more than 400 phones we are thinking about a bulk procedure to install them.
Is there a way to check if LSC installation has been deployed well and if LSC is installed on phones directly from the CUCM?
From the documentation I only found the way to check it from the IP phone menu
Thanks and regards
Marco
09-24-2015 07:53 AM
09-25-2015 03:52 AM
Also if you are deploying 802.1X you might find this community document of great interest.
https://supportforums.cisco.com/document/73611/ip-phone-security-and-ctl-certificate-trust-list
Also consider Supplicant Link State Changes on the IP phones Switch Port, another great document attached.
Good luck with your project.
Greg
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: