IP Phones w/AnyConnect on ASA. Can't call other remote phones

[gmgarrian]

I also posted this in the VPN forum:

I have a CUCM BE environment with a number of remote users with 8961 phones connecting to an ASA 5501 via AnyConnect.  The phones register fine and can make inbound/outbound calls as well as four digit dialing to other users at the corporate site.

The problem is when a remote user tries to four digit dial another remote phone.  The called phone will ring but there is dead air once answered and then the line goes dead.

This sounds like a routing issue to me.  Can anyone point me in the right direction to get AnyConnect clients to be able to reach each other?

I've attached the config for the ASA.

Thanks!

[ahmed_zayed]

Hello

Did you try :

same-security-traffic permit intra-interface

same-security-traffic permit inter-interface

Regards

Ahmed