03-25-2007 11:45 AM - edited 03-14-2019 08:40 PM
Hi.
I have a IPCCX v 4.5 and i need to change the ip address of this server. Do anyone know how to do this ?
I have tried to do that is specified here.
http://cciev.wordpress.com/2006/06/04/changing-ip-address-registry-settings/
But the service is in partical service. N? agents can connect.
any idees ?
/Soren
03-26-2007 03:10 PM
Check the section under Chapter 9, CRS Serviceability Utility from the UCCX admin guide
03-27-2007 11:16 AM
Hi,
Thanx for your replay, but unfortionaly, this is not working. The server is comming up in partical in service. I have also done som regedit and still it is not good.
after the regedit i could get the appadmin up, but before ther regedit the server is just booting.
any more good idees ?
03-27-2007 04:46 PM
have you tried the IPUpdate tool suggested in my earlier post?
If that fails try the following
1. Go to C:\Program Files\Spanlink, and copy the entire folder to a safe location. Delete
the Spanlink folder.
2. Go to Registry, and copy the HKEY_LOCAL_MACHINE\SOFTWARE\Spanlink hive to a safelocation. Delete the Spanlink hive.
3. Re-run CRS setup.
03-27-2007 03:53 AM
Open a cmd prompt.
Run IPUpdate from C:\Program Files\cisco\desktop_config\util, and update the IP address.
Reboot
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: