cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
928
Views
0
Helpful
2
Replies

Is there a way to clear the "Phone Load Name" field via Bulk Administration?

jfellenbaum
Beginner
Beginner

CUCM 7.1(5) - I have many phones that have a phone load specified in the phone load name field.  Is there a way to clear this field using the Bulk administration drop down? Thanks

1 Accepted Solution

Accepted Solutions

mhansen
Enthusiast
Enthusiast

Go to Bulk Administration - Phones - Update Phones - Query

Search for the phones you want to update, then you will see "Phone Load Name". Just check the box, then leave the field blank. Apply the changes and reset the phones. I would do this after hours as the phone firmware might update if your device defaults are different than what you had entered manually.

View solution in original post

2 Replies 2

mhansen
Enthusiast
Enthusiast

Go to Bulk Administration - Phones - Update Phones - Query

Search for the phones you want to update, then you will see "Phone Load Name". Just check the box, then leave the field blank. Apply the changes and reset the phones. I would do this after hours as the phone firmware might update if your device defaults are different than what you had entered manually.

jfellenbaum
Beginner
Beginner

As a side note - when you click submit - check the status of the submitted job via the Job Scheduler under Bulk Administration - Activate the Job if Necessary - If the Job has a status of "Pending", then make sure that the following services are activated:

     Cisco Administrative XML Layer (AXL) Web Service

     Cisco Bulk Provisioning Service (BPS)

     Cisco Tool for Auto-Registered Phones Support (TAPS) Service

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: