ISR SRST License files?

[UCcomp2007]

A few questions.

1.  Are their actual SRST license files that needed to be uploaded to a 2800 series ISR?  Or is this on the "honor" system

2.  If license files requried on ISR 2800 series AND you have to re-ip the gateways, do you have to have new SRST license files generated/applied by Cisco.

3.  ISR 4300 - Will there be actual SRST liense files that need to be uploaded?  Or will it be on "honor" system.

thank you in advance.

[Nadeem Ahmed · Accepted solution]

ISR G1 do not require license. The product family 18XX, 28XX, and 38XX remains unchanged and will not adopt the licensing,  packaging and universal image concept  which is outlined for the ISRG2 family .

changing ip will not make difference

 http://www.cisco.com/en/US/prod/collateral/routers/ps5854/product_data_sheet0900aecd804e773d.html

Sames goes to ISR G3 4XXX its RTU honor based.

http://www.cisco.com/c/en/us/td/docs/routers/access/sw_activation/SA_on_ISR.html

[Terry Cheema · Accepted solution]

SRST is Right To Use (RTU) - you don't need to register any PAK or upload any specific license files for SRST. However before you can configure that you need uc9 technology pack and accept the EULA from CLI.

Ref: http://www.cisco.com/c/en/us/td/docs/routers/access/sw_activation/SA_on_ISR.html#pgfId-1204791

Ref for ISR 4K: http://www.cisco.com/c/en/us/td/docs/routers/access/4400/software/configuration/guide/isr4400swcfg/bm_isr_4400_sw_config_guide_chapter_0101.html#task_F3FCF5F121E64998AB888E13E1BA1858

Activating CME-SRST Feature License

The Cisco ISR G2 comes with a 60-day evaluation license. After 60 days, the license changes to “right to use”. The customer is required to pay for the CME-SRST feature license which is valid for 12 years.

---

Note CME-SRST RTU license is introduced in Cisco IOS release 15.1(3)T and higher.

Prerequisites

• UCK9 license
• Cisco ISR G2 already accepts UC CLIs
• CME-SRST feature must be configured

-Terry

Please rate all helpful posts

[Terry Cheema]

Edit: SRST is Right To Use (RTU) - you don't need to register any PAK.

It was typo I meant you dont need to register any PAKs (same as before)

[Aman Soi]

[+5] to Terry and Nadeem.

these licenses would show as below under Evaluation period of 60 days. the snapshot captured before July 24.

Feature: cme-srst                         Version: 1.0

                License Type: EvalRightToUse

                License State: Active, In Use

                   Evaluation total period: 8  weeks 4  days

                   Evaluation period left: 3  weeks 3  days

                   Period used: 5  weeks 0  day 

                   Transition date: Jul 24 2016 16:29:20

                License Count: 20/0  (In-use/Violation)

After the evaluation period gets expired , status would change as below. The snapshot captured after July 24,2016

Feature: cme-srst                         Version: 1.0

                License Type: RightToUse

                License State: Active, In Use

                License Count: 20/0  (In-use/Violation)

regds,

aman

[Terry Cheema]

+5 Aman my friend hope you are doing good.

[UCcomp2007]

Thanks to all, Much appreciated