08-20-2015 07:23 AM - edited 03-17-2019 04:03 AM
I am deploying Jabber Guest 10.6.7 to a UCS-C220 M3 running ESXi 5.1
During the ova deployment, I am not prompted to enter an IP address or any network information...Has anyone ran into this issue? Thanks in advance! Attached is a screenshot. Right above "Ready to Complete", I would expect to see "Properties"
08-20-2015 08:12 AM
08-20-2015 01:51 PM
That's not really helpful Jaime.
The guide states the networking would be configured as part of the OVA deployment. In reality, I too, do not see the networking step. It goes from mapping the VLAN to the complete step - and manually changing the IP via the network.config file does not resolve the issue in my case.
08-20-2015 01:53 PM
Are you using vCenter????
08-20-2015 01:54 PM
Not for this particular deployment. It is a stand-alone host.
08-20-2015 01:56 PM
Take a close look at the link, there are TWO set of instructions, one set with vCenter, and another one without vCenter.
08-20-2015 02:21 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide