cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
386
Views
0
Helpful
5
Replies

Kill/end a specific call.

guillermohurtado
Beginner
Beginner

Hello,

Is there a command to kill/end a specific call?

Regards.

5 REPLIES 5

guillermohurtado
Beginner
Beginner

Hello,

Is there a command to kill/end a specific call on a Cisco GW AS5300/AS54000 ??

Regards.

If you use 'show call active voice brief' you can get the 4 digit HEX ID for a call based on calling/called number and remote IP address and channel.

Then you can use the command:

clear call voice causecode id , you can also try using the called/calling options instead of ID.

hth,

nick

Hello,

I can't run that command. I just have:

GW#clear call ?

fallback VoIP Fallback

threshold Clear stats about resource measurement

treatment Clear commands for call admission

Is there another way to perform this?

Best regards.

It sounds like you need to upgrade IOS to use this command.

There isn't another way, unless you shut down voiceports/controllers.

-nick

Hello,

I'm running Version 12.3(26) over a AS5300, isn't it the latest?

Regards.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: