Hello,
I am using LPCOR in CME 11 for my SIP IP Phones. I have tested it with calls phone to phone and it works:
voice lpcor enable
voice lpcor custom
group 1 Local_Nacional
group 2 Celular_044_045
group 3 LDI
group 4 LDM
group 5 20
group 6 40
group 7 50
group 8 60
!
voice lpcor policy Local_Nacional
service fac
no accept Local_Nacional
accept 20 fac
accept 40 fac
accept 50 fac
accept 60 fac
!
voice lpcor policy Celular_044_045
service fac
accept 40 fac
accept 50 fac
accept 60 fac
!
voice lpcor policy LDI
service fac
accept 50 fac
accept 60 fac
!
voice lpcor policy LDM
service fac
accept 60 fac
!
voice lpcor policy 20
!
voice lpcor policy 40
!
voice lpcor policy 50
!
voice lpcor policy 60
!
In my test I use two IP phones, one of the has lpcor incoming (key) and the other one has lpcor outgoing (lock) and it works.
I will use policies 20, 40, 50 and 60 (keys) for IP Phones (voice register pool and lpcor incoming) and I was thinking to use the othe polices (locks) for dial-peer voice pots. I saw I can apply lpcor to dial-peer voice voip, but not to pots. Is there any way to get this work? I need to limit groups of users to call, for example, to international calls, or long distance, etc. I can only use one lpcor in trunkgroup, so it can't be possible to make what I want if I apply the lpcor in the trunkgroup.
Kind regards.