LSC installed successfully on my IP PHone 7965, how do i change the settings of authentication mode from username and password to LSC Certificate authentication on IP Phone 7965. i can connect successully to VPN using username and password everytime when it reboots it keep asking for the username and password. Please i need help, all help appriciated. Thanks
webvpn gateway remotephone
ip address 192.168.0.100 port 443
ssl trustpoint pbx_cert
webvpn install svc flash:/webvpn/anyconnect-win-3.1.05152-k9.pkg sequence 1
webvpn context remotephone
ssl encryption 3des-sha1 aes-sha1
ssl authenticate verify all
policy group remotephone
svc address-pool "remotephone" netmask 255.255.255.0
svc default-domain "pbx.com"
svc rekey method new-tunnel
svc split include 192.168.0.100 255.255.255.255
gateway remotephone domain remotephone
ca trustpoint pbx_cert
You can change the 'Client Authentication Method' to Certificate based under VPN Profile setting on CUCM page. Please check the following link
Let us know if it helps.
Thanks for the reply but i'm using call manager epress 8.6 on cisco 2851. Please letme know if you have any suggestions are even the document to refer i greatly appriciate your help. Thanks
You can configure certificate based authentication on CME as per the following link for CME administration guide.
Once again thanks for the reply i did went through that documents prior posting my issue its does not really expalin what im looking for. Thanks