cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1106
Views
0
Helpful
1
Replies

Lync - Cucm transfer using refer

Piotr Mlodawski
Level 1
Level 1

Hello,

I am experiencing an issue when trying to perform a call transfer from Lync to a Cisco Phone with SIP REFER method.

I am using CUCM 10.5(2)SU2a and Lync 2013. Lync integrated with CUCM over a SIP trunk.

During a call between Cisco IP Phone and Lync Client, I am trying to transfer a call to another Cisco IP phone but the transfer fails.

I can see a REFER message sent to CUCM.

When transfering a call from Cisco IP Phone to Lync, the transfer works

When performing the transfer using RE-INVITE (REFER disabled on Lync) all transfers work

 

Lync Normalization script is implemented on the SIP trunk

Does anybody know the reason of this behavior?

 

I have used the following integration guide:

http://www.cisco.com/c/dam/en/us/solutions/collateral/enterprise/interoperability-portal/uc-manager.pdf

There is a following note:

A later release of Cisco UCM fixing the defects CSCum00523 and CSCun13435 is required to resolve REFER and Call Hold issues observed in testing.

Are those defects fixed in CUCM 10.5(2)SU2a?

 

Regards

Piotr

 

1 Reply 1

etmarcof
Level 3
Level 3

Hi Piotr,

Thanks for sharng the solution I have CUCM 10.5(2)SU1 and suffering of this problem.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: