10-18-2011 07:03 AM - edited 03-16-2019 07:34 AM
Hi,
I need to make outgoing calls with DID display instead of the main number
i will told by the teleco to send the last 4 digits over in order for DID to work on outgoing calls
how can i achieve it? thanks.
10-18-2011 07:59 AM
Hi Robbie,
I'm afraid we need a bit more information before being able to answer your question. At this point, I'm not even sure if you're using CME or full blown CUCM.
If it's CUCM, you'll want to use a calling number transformation in your route pattern to get the number to 4 digits. You can also use a transformaiton pattern applied to your gateway.
If it's CME, you'll have to put some transformations on the outgoing dial peers to manipulate the number.
hth. Please post more information if not.
10-18-2011 08:08 AM
Hi Rick,
CUCM 8.5
Thanks for your advice.
I will give a try on it
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide