01-20-2012 02:11 PM - edited 03-16-2019 09:08 AM
Hi,
I have a costumer, that has 60 voice register pool configured(sip phones) , and 40 ephones (SCCP) in the same router, and all is working perfectly.
Follow the show configs :
voice register global
max-dn 288
max-pool 96
telephony-service
max-ephones 110
max-dn 288
My question is:
In the router , can i configure and use 96(Sip phones) + 110(SCCP phones) = 206 total, without problems?
Tks
Solved! Go to Solution.
01-20-2012 02:41 PM
On a 2851 you can have up to 100 SCCP phones and up to 100 SIP phones, registered simultaneously.
Also, per cisco licensing terms:
Total number of connected IP phones cannot exceed Maximum Total listed including SCCP and SIP phones on the same router.
From: http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/cme86spc.htm.html
For the 2851, 'Maximum Total' is also 100. However, this limitation is not enforced.
01-20-2012 02:20 PM
Which router model is that ?
01-20-2012 02:29 PM
Cisco 2851 (revision 53.50) with 241664K/20480K bytes of memory.
01-20-2012 02:41 PM
On a 2851 you can have up to 100 SCCP phones and up to 100 SIP phones, registered simultaneously.
Also, per cisco licensing terms:
Total number of connected IP phones cannot exceed Maximum Total listed including SCCP and SIP phones on the same router.
From: http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/cme86spc.htm.html
For the 2851, 'Maximum Total' is also 100. However, this limitation is not enforced.
01-20-2012 02:50 PM
If i understood, the cme version is 7.1, i can use both, but could be necessary an upgrade to more memory, correct?
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/cme71spc.htm
Tks
01-20-2012 02:54 PM
You should have at least 512MB to run recent IOS with a large number of phones.
Thanks for the nice rating and good luck!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: