Max people in a barged shared line

[joel]

CCM 4.1.3

I have a shared line setup with 10 phones and we would like all of them to be on the same call. when the 3rd person tries to enter a call, it says "exceeded barging capabilities".

Is there a max number of phones that can be on the same barged shared line.

thanks in adv,

:JoeL

[Jaime Valencia]

Using phone bridge max 3, using CFB depending of bridge capabilities and config

HTH

java

if this helps, please rate

[joel]

thanks java,

I have "built in bridge" turned on....then I'm using the phone bridge right?

to use CFB do I need to use cbarge or do I need to disable "built-in bridge"

[Jaime Valencia]

If you're using just barge and built-in bridge, yes, then only 3 users max.

You need to configure a valid MRGL for the phones that contains a CFB and use cBarge to use a CFB that supports more users.

Table 1-2 Barge with Shared Conference Bridge (cBarge) Configuration Checklist

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/7_1_2/ccmfeat/fsbarge.html#wp1098676

HTH

java

if this helps, please rate

[joel]

I use CCM 4.1.3, does this version have Single button Barge/cBarge?

I don't even see this option in my lab CCM 7.0 server...

pls help,

:JoeL

[Jaime Valencia]

Barge Using Shared Conference-cBarge Softkey

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/4_1_3/ccmfeat/fsbarge.html#wp1036369

Refer to the features and services guides from whatever version you want and there will be a barge chapter

HTH

java

if this helps, please rate

[joel]

that was not the question....

if you look at the version 7 and 4.1.3 Feature guide, in the 7 it has a Single button Barge/cBarge...that was the question.

[Jaime Valencia]

If it's not in the guide then the answer is obviously NO, otherwise config instructions would be there.

HTH

java

if this helps, please rate

[joel]

that was not the question....

if you look at the version 7 and 4.1.3 Feature guide, in the 7 it has a Single button Barge/cBarge...that was the question.

[joel]

sure i do get that it's obvious,

but like i said in the second part, I don't even see this in my CCM 7.0 server?