cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
528
Views
3
Helpful
4
Replies

Media Resources (Xcoder, Conferencing and MTP) are not getting registered

Abhishek Sharma
Level 1
Level 1

Hi All,

I have a situation where Media Resources (Xcoder, Conferencing and MTP) are not getting registered. It gives status as for Xcoder, Conferencing and MTP :

Transcoding Oper State: ACTIVE_IN_PROGRESS - Cause Code: CCM_REGISTER_FAILED
TCP Link Status: NOT_CONNECTED, Profile Identifier: x

 

Any suggestion to resolve this ?

 

Thanks !

4 Replies 4

Suresh Hudda
VIP Alumni
VIP Alumni

please explain it little bit more, where are you trying to register them? is it CUCM or CME ?

If cme, then post the show run plz.

 

Suresh

Thanks for your reply

Its CUCM v8.

In CUCM, Xcoder, Conferencing and MTP status is unknown

On GW, i am getting error as mentioned in my first post.

 

I have checked DSP staus as OK

profiles are also associated with ccm.

There can be below issues here..

1. Might be callmanager service OR Cisco IP Voice Media Streaming App service is not activated on CUCM.

2. Have you given same profile name in CUCM while configuring these (as per gateway config)?

3. Is CUCM is reachable from voice router ?

If all above are okay then please share the gateway' running configuration.

Suresh

Hi,

In addition to what Suresh has asked, please make sure you are using correct names[Device Name] in CUCM with what u have configured in Router.

 

regds,

aman

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: