cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
286
Views
0
Helpful
1
Replies
Highlighted
Beginner
Beginner

mgcp and sip co-location

I have a a router acting as Mgcp gateway for my CUCM. I would like my CUCM to connect to a SIP PROVIDER using the same router. Is it possible to use 1 router to run both MGCP and SIP. Any examples ???

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Hall of Fame Cisco Employee

Yes, just configure the MGCP bit and the SIP dial-peers on the same ISR. Follow any regular guide on SIP config as the configurations do not mix. You can even run H323 as well if you want.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

View solution in original post

1 REPLY 1
Highlighted
Hall of Fame Cisco Employee

Yes, just configure the MGCP bit and the SIP dial-peers on the same ISR. Follow any regular guide on SIP config as the configurations do not mix. You can even run H323 as well if you want.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

View solution in original post

Content for Community-Ad