cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

1315
Views
10
Helpful
6
Replies
Highlighted

MGCP FXS ports requires a license in CUCM9

Hello!

I am connecting Some analoge phones to VG350 FXS ports which is  configured as a MGCP Gateway in CUCM. I beleive MGCP did not requires any license for it. Can some confirm this ? is there any Cisco doc on it ?

Thanks & Regards,

6 REPLIES 6

MGCP FXS ports requires a license in CUCM9

Hi,

I don't have a doc confirming this but I have a VG220 running on CUCM BE6000 ver 9.0 and I did not need any aditional licenses.

The licenses is only for the users depending on what type of licensing you make use of the CUWL.

Voice CCIE #37771
Beginner

MGCP FXS ports requires a license in CUCM9

Hello,

Please check if this helps:

https://supportforums.cisco.com/thread/2218302

Advisor

MGCP FXS ports requires a license in CUCM9

hi,

u would be requiring UCL essential license.

regds,

aman

MGCP FXS ports requires a license in CUCM9

Ok, what about if we make it H323/SIP GW. How the user licenses can be tracked ?

Beginner

MGCP FXS ports requires a license in CUCM9

If you make it an H323 gateway, then I dont think you would be registering any phones to the CUCM. All you need to do is to configure dial-peers to route the calls. So I dont think you would need any licenses then.

Regards

Sam

Advisor

MGCP FXS ports requires a license in CUCM9

Hi Sambit,

Technically u are correct but legally I think u would be requiring license.

even the ordering guide says Analog devices are supported with Essential USer license  and must be purchased through UCL.

http://www.cisco.com/web/partners/downloads/partner/WWChannels/technology/ipc/downloads/finalcopy.pdf

regds,

aman

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards