cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays
1718
Views
10
Helpful
6
Replies
Highlighted
VIP Rising star

MGCP FXS ports requires a license in CUCM9

Hello!

I am connecting Some analoge phones to VG350 FXS ports which is  configured as a MGCP Gateway in CUCM. I beleive MGCP did not requires any license for it. Can some confirm this ? is there any Cisco doc on it ?

Thanks & Regards,

6 REPLIES 6
Highlighted

Hi,

I don't have a doc confirming this but I have a VG220 running on CUCM BE6000 ver 9.0 and I did not need any aditional licenses.

The licenses is only for the users depending on what type of licensing you make use of the CUWL.

Best Regards
Highlighted
Beginner

Hello,

Please check if this helps:

https://supportforums.cisco.com/thread/2218302

Highlighted

hi,

u would be requiring UCL essential license.

regds,

aman

Highlighted

Ok, what about if we make it H323/SIP GW. How the user licenses can be tracked ?

Highlighted

If you make it an H323 gateway, then I dont think you would be registering any phones to the CUCM. All you need to do is to configure dial-peers to route the calls. So I dont think you would need any licenses then.

Regards

Sam

Highlighted

Hi Sambit,

Technically u are correct but legally I think u would be requiring license.

even the ordering guide says Analog devices are supported with Essential USer license  and must be purchased through UCL.

http://www.cisco.com/web/partners/downloads/partner/WWChannels/technology/ipc/downloads/finalcopy.pdf

regds,

aman

Content for Community-Ad