cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
158
Views
0
Helpful
1
Replies

Mobility Manager1.2 - dial delay by route point !#

cjrchoi11
Beginner
Beginner

configured MM route point extension !# as per installation guide but it makes dial delay (15 sec inter-digt timeout) for all includes between IP phones. How can I resove this?

CCM5.0.4

Thanks in advance,

1 Accepted Solution

Accepted Solutions

Brandon Buffin
Advisor
Advisor

This route point should be in a special partition created for this purpose. The partition should only be accessible by the calling search space created for and assigned to the CTI ports for Mobility Manager. Sounds like you have the route point in a partition that is accessible by all phones. Take a look at the following doc.

http://www.cisco.com/en/US/products/ps6567/products_installation_guide_chapter09186a0080645bc0.html

Hope this helps. If so, please rate the post.

Brandon

View solution in original post

1 Reply 1

Brandon Buffin
Advisor
Advisor

This route point should be in a special partition created for this purpose. The partition should only be accessible by the calling search space created for and assigned to the CTI ports for Mobility Manager. Sounds like you have the route point in a partition that is accessible by all phones. Take a look at the following doc.

http://www.cisco.com/en/US/products/ps6567/products_installation_guide_chapter09186a0080645bc0.html

Hope this helps. If so, please rate the post.

Brandon

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers