cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

777
Views
0
Helpful
4
Replies
Highlighted

Mobility remote destination number of rings

Is there any way to change the amount of rings it takes for a cell phone to begin to ring when setting up Cisco Mobility? Currently it takes about 2 rings before our cell phones rings with mobility enabled. I was wondering if there was any way to change this to about 1 ring.

I'm on Call Manager 8

4 REPLIES 4
Highlighted
Hall of Fame Cisco Employee

Mobility remote destination number of rings

Have you already played with these settings??

Answer Too Soon Timer

Delay Before Ringing Timer

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate
Highlighted

Mobility remote destination number of rings

In addition to Java's response: Be aware that many cell phones have a delay before they start ringing which is beyond the control of CUCM. You can pin this down by watching your gateway/trunk to mark the time between when the SETUP/INVITE is sent and when the phone actually rings. Even if you set the Delay Before Ringing Timer to zero (0), you may still experience a ring or two worth of delay. Your only way to combat this is to raise the Call Forward No Answer timer on the DN and the Answer Too Late Timer.

Highlighted

Mobility remote destination number of rings

yes. I haven't noticed a difference. It's still taking at least 3 rings before the cell phones ring. I wasn't sure if this was standard or not or if this can be controlled.

Highlighted
Beginner

Re: Mobility remote destination number of rings

Take a good look a your Route Patterns and try to specify them, if there is an exact match it should ring after a single ring om the deskphone.

Sent from Cisco Technical Support iPad App

CreatePlease to create content
Content for Community-Ad

Cisco COVID-19 Survey