Monitor FXO port PSTN line button CUCM.

[Marwan Urabi]

Hi,

is there any way to make special button at phone to monitor PSTN FXO line under CUCM 11.X 

same as CME configuration .

dial-peer voice 8000 pots

 description ** Land Line 1 **

 destination-pattern 9000

 direct-inward-dial

 port 0/0/0

 forward-digits all

 no sip-register

ephone-dn  100  dual-line

 ring internal primary

 number 800

 label Land Line 1

 no huntstop

 trunk 9000 transfer-timeout 40 monitor-port 0/0/0

Regards

[HARIS_HUSSAIN]

We can monitor the Trunk utilization in RTMT, but I think CUCM doesn't have such functionality yet.

Please rate and mark correct posts<<

[Marwan Urabi]

Hi,

Frankly it's strange if this not available at CUCM !!

[Mohammad Ramadan A.Hafiez]

This reply might look very late but just wanted to participate as I had a similar scenario on cucm 11.
in my case I have used a deducted extension that the FXO port are forwarded to it using the h323 connection plar opx xxxx, and using subscription enabled with appropriate calling search space, you will now have the ability to check the FXO port availability such as any extension, and you can have this extension shared line.

If you reached to a better solution, kindly share with me yours :)