cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
753
Views
0
Helpful
2
Replies
Highlighted
Beginner
Beginner

Monitor FXO ports with RTMT

Hello,

Is there a way to monitor a specific group of FXO ports on a gateway and configure RTMT to send out an alert if all of those ports are in use?  I have found some a couple of posts hinting that it should be possible but I'm not sure how to set it up in RTMT.  I've been trying to set it up by going under Performance, Cisco MGCP FXO Device and PortStatus but that doesn't seem right.  Any suggestions would be helpful.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Rising star

You can configure alerts to send you an email when they are seen. Below is a link for the RTMT Admin Guide for 8.5.1 (I don't know what version of CUCM you have but this should be fine)

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/service/8_5_1/rtmt/RTMT.html

Regards,

Yosh

HTH Regards, Yosh

View solution in original post

2 REPLIES 2
Highlighted
Rising star

You can configure alerts to send you an email when they are seen. Below is a link for the RTMT Admin Guide for 8.5.1 (I don't know what version of CUCM you have but this should be fine)

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/service/8_5_1/rtmt/RTMT.html

Regards,

Yosh

HTH Regards, Yosh

View solution in original post

Highlighted
Beginner
Beginner

After reading through the guide I figured out a way to get the information I want.

Thanks