07-10-2011 11:46 AM - edited 03-16-2019 05:52 AM
Hi,
We are monitoring the BLF status of managers and when we use the same DN in different partitions, we are facing a issue:
The issue is as follows:
1) I have DN 6094 in first partition (partition-1)
2) I have DN 6094 in second partition (partition-2)
3) I am monorting the status of both the lines on my phone 6078. But when I lift the receiver of 6094 (of one phone) both the BLF buttons glow on 6078.
As the result I am not able to monitor the status of the line individually.
Can someone guide me..
07-10-2011 12:59 PM
What's the reason you have the same DN in two partitions ?
07-10-2011 01:19 PM
You have the same monitoring CSS which see both partitions of this DN
07-10-2011 02:01 PM
you must not have the same number in two different partitions when they are reachable by the same CSS
Part 1: 202
part 2 : 202
CSS 1 = part1 + Part 2
the phone with CSS1 will match always 202 in part1
This is not a good designe
Regards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: