cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
3078
Views
0
Helpful
3
Replies
Highlighted
Beginner

Monitoring DSP resources, SNMP OID

Hi again, cisco gurus!

Have been looking for SNMP OID that allows to monitor the number of DSP-channels active on Cisco router for some days.

Has someone investigated this task? completely perplexed

thanks,

Boris Borodin

3 REPLIES 3
Highlighted
Beginner

Check out this link

http://www.cisco.com/en/US/docs/ios/netmgmt/configuration/guide/nm_dsp_notifications.html#wp1054016

Also some additional information --

  • dspu—Sends a notification whenever the operational state of the physical unit (PU) or the logical unit (LU) changes or activation failure is detected. This is from the CISCO-DSPU-MIB, and the notifications are:

    enterprise 1.3.6.1.4.1.9.9.24.1.4.4

    1newdspuPuStateChangeTrap

    2 newdspuPuActivationFailureTrap

    enterprise 1.3.6.1.4.1.9.9.24.1.5.3

    1 newdspuLuStateChangeTrap

    2 dspuLuActivationFailureTrap

  • dsp—Sends a notification whenever the DSP card goes up or down. This is from the CISCO-DSP-MGMT-MIB, and the notification is:

    enterprise 1.3.6.1.4.1.9.9.86.2

    1 cdspMIBCardStateNotification

  • Also you could check out these two MIBS, from website http://www.cisco.com/go/mibs

    CISCO-DSP-MGMT-MIB

    CISCO-DSP-MGMT-CAPABILITY-MIB

    Hope that helps,

    CM

    Highlighted

    Hi! I have similar question.
       I have 2811 that uses like onramp/oframp fax-server.
        I need to monitor number of faxes that DSP is operates in time. I want make some graphs (in cacti or MRTG) that show load dsp
        resources by faxe's for optimizing number of DSP card in router and monitoring  max fax load time.
        I search in MIB but couldn't find strict that i want.
        May be you have some solution for such kind of question.
    Tank you.

    Highlighted

    Medvec_Rc

    I have the some problem? Can you resolved it?

    I have 2811 that uses like fax onramp, and need the number of fax is received at time.

    Who can helpme.