cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
configure & troubleshoot anyconnect
139
Views
5
Helpful
4
Replies
Highlighted
Beginner

Need Help for SIP trunking

Hi, I have a 4321 ISR Router,
Cisco IOS XE Software, Version 16.11.01a,
CME 12.6
I want to connect my via a SIP trunk to my ITSP
I can not, I have this message that appears when I configure the SIP trunk/

 

#credentials username TEST password 0 TEST2019 realm eylim.local
Failed type 6 encryption on password

1 ACCEPTED SOLUTION

Accepted Solutions
Rising star

Re: Need Help for SIP trunking

1) For 16.11.1 a master key must be pre-configured before configuring type 6 passwords.

2) The master key is not displayed in configuration.

 

to configure master key using below command

 

conf t

    key config-key password-encrypt <MASTER PASSWORD>

     password encryptoin <ENCYRPTION TYPE>

 

If the master key is not pre-configured you get the error  "Failed type 6 encryption on password" Also, type 6 password supports only ENCRYPTED Format and not clear text. So use type 0 while configuring it will be saved as type 6. 

 

*** Please rate helpful post; Mark "Accept as a Solution" if applicable

Thanks,
Haris

 

4 REPLIES 4
Hall of Fame Cisco Employee

Re: Need Help for SIP trunking

Watch: Updates to SIP Trunking for On-Prem Deployments

 

https://community.cisco.com/t5/collaboration-documents/voice-of-the-engineer-voe-events/ta-p/3621363

 

Start at 1:19:06

HTH

java

if this helps, please rate
Beginner

Re: Need Help for SIP trunking

Hi jaime

Thx for your reply, but I can't have access

Access Denied

Rising star

Re: Need Help for SIP trunking

1) For 16.11.1 a master key must be pre-configured before configuring type 6 passwords.

2) The master key is not displayed in configuration.

 

to configure master key using below command

 

conf t

    key config-key password-encrypt <MASTER PASSWORD>

     password encryptoin <ENCYRPTION TYPE>

 

If the master key is not pre-configured you get the error  "Failed type 6 encryption on password" Also, type 6 password supports only ENCRYPTED Format and not clear text. So use type 0 while configuring it will be saved as type 6. 

 

*** Please rate helpful post; Mark "Accept as a Solution" if applicable

Thanks,
Haris

 

Beginner

Re: Need Help for SIP trunking

Hi HARIS

thx for your reply.

Please can you check my question aboutwhitch license do I need ?

Thx

CreatePlease to create content
Content for Community-Ad
June's Community Spotlight Awards