cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2982
Views
0
Helpful
1
Replies

Need to set Speed and Duplex setting in NIC teamed CUCM.

bijoyjackjesse
Level 1
Level 1

Hi

I've had LAN issues stating Duplex mismatch - which led to the port connected to the CUCM MCS server.

Now Fault tolerance is configured in the CUCM NIC.

it does not allow me to run the show network eth0 cmd. instead it asks to use the cmd show network failover

===============

Guys,

I have a issue with the NIC teaming..

Fault tolerance is configured in my cucm.

I'd like to set the Speed and Duplex from the CM's End..

iI've added the Show network failover

admin:show network failover

eth0 has been overridden by Network Fault Tolerance.

To view the Ethernet port configuration, please use following command:

show network failover

admin:show network failover

Bond 0

DHCP         : disabled           Status     : up

IP Address   : 138.241.118.34     IP Mask    : 255.255.255.224

Link Detected: yes                Mode       : Auto disabled, full, 100MB/s

Ethernet 0

DHCP         : disabled           Status     : up

IP Address   :                    IP Mask    :

Link Detected: yes                Mode       : Auto enabled, Half, 100MB/s

Ethernet 1

DHCP         : disabled           Status     : up

IP Address   :                    IP Mask    :

Link Detected: yes                Mode       : Auto enabled, Half, 100MB/s

DNS

Primary      :                    Secondary  :

Options      : timeout:5 attempts:2

Domain       : localdomain

Gateway      : 138.241.118.33 on Ethernet bond0

---------------------------------------------------------------------------

Now i need the NIC connected to the switch to be set to Full duplex and speed 100MB/s

would using the command #set network nic eth0 speed/duplex  solve my issue...

And would i loose connectivity or would the phone systems go down for a brief period of time.

Any help highly appreciated...

Thank you guys

1 Accepted Solution

Accepted Solutions

Aman Soi
VIP Alumni
VIP Alumni

Hi Jack,

You first need to disable NIC teaming which can be done through set network faiover disable..

Now to set the duplex and speed , u need to follow the commands

set network nic eth0 speed 100

set network nic eth0 duplex full

This would lead to downtime till the time LAN port does not come UP.

Again to set NIC teaming , follow set network faiover enable.

regds,

aman

View solution in original post

1 Reply 1

Aman Soi
VIP Alumni
VIP Alumni

Hi Jack,

You first need to disable NIC teaming which can be done through set network faiover disable..

Now to set the duplex and speed , u need to follow the commands

set network nic eth0 speed 100

set network nic eth0 duplex full

This would lead to downtime till the time LAN port does not come UP.

Again to set NIC teaming , follow set network faiover enable.

regds,

aman

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: