cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1495
Views
0
Helpful
3
Replies
Highlighted
Participant

NIM card: how to determine slot and subslot for command card type e1 ?

 

We have new installation for PRI line. we have ISR4321 router and NIM-2MFT-T1/E1 - T1/E1 Serial Module with PVDM 64 installed.

 

Router#sho inventory
NAME: "Chassis", DESCR: "Cisco ISR4321 Chassis"
PID: ISR4321/K9        , VID: V04, SN: FDO2225A2QT

NAME: "Power Supply Module 0", DESCR: "110W AC Power Supply for Cisco ISR 4320"
PID: PWR-4320-AC       , VID:    , SN:

NAME: "Fan Tray", DESCR: "Cisco ISR4320 Fan Assembly"
PID: ACS-4320-FANASSY  , VID:    , SN:

NAME: "module 0", DESCR: "Cisco ISR4321 Built-In NIM controller"
PID: ISR4321/K9        , VID:    , SN:

NAME: "NIM subslot 0/2", DESCR: "NIM-2MFT-T1/E1 - T1/E1 Serial Module"
PID: NIM-2MFT-T1/E1    , VID: V05, SN: FOC222339CG

NAME: "subslot 0/2 db module 0", DESCR: "PVDM4-64 Voice DSP Module"
PID: PVDM4-64          , VID: V02, SN: FOC222314YE

NAME: "NIM subslot 0/0", DESCR: "Front Panel 2 ports Gigabitethernet Module"
PID: ISR4321-2x1GE     , VID: V01, SN: JAB092709EL

NAME: "module R0", DESCR: "Cisco ISR4321 Route Processor"
PID: ISR4321/K9        , VID: V04, SN: FDO22241V8Y

 

NAME: "module F0", DESCR: "Cisco ISR4321 Forwarding Processor"
PID: ISR4321/K9        , VID:    , SN:

 

 

While configuring on router how we will determine card type e1 command? ie slot and subslot?

 

can some body explain it?  from the above inventory how will i determine slot and subslot?

3 REPLIES 3
Highlighted
Participant

Re: NIM card: how to determine slot and subslot for command card type e1 ?

yes i got it.

 

NAME: "NIM subslot 0/2", DESCR: "NIM-2MFT-T1/E1 - T1/E1 Serial Module"
PID: NIM-2MFT-T1/E1    , VID: V05, SN: FOC222339CG

 

this is what we need to check

 

so command will be

card type e1 0 2

Highlighted
Hall of Fame Master

Re: NIM card: how to determine slot and subslot for command card type e1 ?

That is correct. 

Highlighted
Advisor

Re: NIM card: how to determine slot and subslot for command card type e1 ?

Hi,

 

you can also refer the below link with Table 1.6 for details

 

https://www.cisco.com/c/en/us/td/docs/routers/access/4400/hardware/installation/guide4400-4300/C4400_isr/Overview.html#32890

regds,

aman