04-06-2016 04:35 PM - edited 03-18-2019 11:54 AM
Hello:
I configured an Inter -Cluster Trunk (Non - Gatekeeper Controlled )
and establishes communication call but can not hear anything .
any idea to solve
Thank you
04-06-2016 04:48 PM
Is there full routing between the endpoints?
Nothing blocking it?
04-07-2016 07:13 AM
04-07-2016 07:18 AM
If this calls are going thru an ICT, there's no GW involvement, not sure why you bring that up...
09-18-2019 12:22 PM
Jaime can you help me on the same issue?
8845 IP Phone->CUCM2 of 3 in US -> ICT over DMVPN ->China->CUCM2->IP Phone
No audio but call connects fine.
Note* Media Termination point required is not checked on the ICT.
Run on all active nodes is not checked on the RL or the SIP Trunk.
Ping Times are 210ms.
I do not have access to CUCM in China. Only US.
CDR from China shows two IP Addresses for destination. 1. Destination IP Address (CUCM 2 US). 2. Media Destination IP Address of US IP Phone.
Helppp
09-18-2019 12:55 PM
Jamie deeper info...
US IP Phone->Specific Route Pattern->RL(Run on all CM Nodes not checked)-> CUCM1->ICT CUCM2(Media Termination Point not checked nor is Run on all Active CM Nodes)->DMVPN 210ms between CUCM's->ICT CHINA CUCM2(not sure what is checked. No access)->China IP Phone
No audio but normal call clearing.
09-18-2019 01:08 PM
More info after looking at ICT in US...
Best Effort... No MTP inserted
MRGL is empty on the ICT
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide