cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
214
Views
0
Helpful
1
Replies

NO CallForwardAll when using OverlapSending

Have a 0.X route pattern using OverlapSending. Everything works OK for PSTN calls.

But when trying to CFwdALL to a PSTN destination is impossible, the diverted number is accepted straight away after 2nd digits.

1 Accepted Solution

Accepted Solutions

mesolak
Cisco Employee
Cisco Employee

Hi,

to overcome this, you need to configure an additional route pattern with a wildcard character, such as "0.!" and put this in a separate partition. Create a additional CSS and assign this on the line CallForward-CSS.

http://www.cisco.com/en/US/partner/products/sw/voicesw/ps556/products_configuration_example09186a008012f948.shtml

HTH

regards

mehmet

View solution in original post

1 Reply 1

mesolak
Cisco Employee
Cisco Employee

Hi,

to overcome this, you need to configure an additional route pattern with a wildcard character, such as "0.!" and put this in a separate partition. Create a additional CSS and assign this on the line CallForward-CSS.

http://www.cisco.com/en/US/partner/products/sw/voicesw/ps556/products_configuration_example09186a008012f948.shtml

HTH

regards

mehmet

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: