01-03-2012 12:58 PM - edited 03-16-2019 08:47 AM
Hello Everyone,
I have a need to configure a Busy Lamp Field on a Cisco 7975G to monitor the status of two DN on another telephone without using the Presence feature.
Here is the scenario .....
User A has two different DN on their 7975G (neither are shared). User B has a need to see anytime User A is on either line, but I am restricted to using one button.
Is this possible on CUCM 8.0?
01-03-2012 01:13 PM
Sorry, cannot be done, only 1 to 1 relationship is available via BLF.
Chris
01-03-2012 01:19 PM
Just a sidenote, CME can do this. "watch phone".
01-03-2012 01:29 PM
Paolo,
This is very good information to know (+5 points for sharing).
Chris
01-04-2012 05:36 AM
Thank you Chris. Also rated your answer, as always concise and correct.
01-03-2012 01:25 PM
Let's try another route then ...... again, no Presence server available ......
I have a shared line ...... the BLF goes red when someone else picks up the shared line. Is there anyway to see which telephone (user) picked up the shared line?
01-03-2012 01:26 PM
Let's try another route then ...... again, no Presence server available ......
I have a shared line ...... the BLF goes red when someone else picks up the shared line. Is there anyway to see which telephone (user) picked up the shared line?
01-03-2012 01:29 PM
Nope, not with CUCM (not sure about CME).
HTH,
Chris
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: