04-17-2007 04:19 AM - edited 03-14-2019 09:00 PM
Hi,
We are trying to configure a sip gateway with the below configuration. The router is installed with 4 fxo ports which i am connecting to a pstn line with the config as below.
dial-peer voice 10 pots
destination pattern 9t
port 0/0/0
forward digits all
When i dial any outside number through sip soft phone ,I am facing one way voice issue.
There is no sip servers as such in the network.
04-17-2007 10:52 AM
Take a look at this document to troubleshoot one-way voice issue...
http://www.cisco.com/en/US/tech/tk652/tk698/technologies_tech_note09186a008009484b.shtml
hieu
04-17-2007 01:26 PM
Hi
Check you have 'IP routing' enabled globally.
Regards
Aaron
Please rate helpful posts...
04-19-2007 12:04 AM
Hi,
When you say there is not sip servers in the network, then how do you intiate the call?
Which sip softphone are you using?
At you sip phone, what do you configure for sip proxy?
I had done test before, basically you need a dial-peer voip using sipv2 point to your sip softphone
Thanks
SS
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide