cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays
785
Views
5
Helpful
7
Replies
mlong0000
Beginner

Outbound Calls from CUCM to PSTN over Verizon SIP Problem

Hi,

I'm having a problem getting outbound calls working over a Verizon SIP trunk. Inbound work ok. The call flow is pretty straight forward Phone -> CUCM -> CUBE -> SIP trunk -> PSTN

Outbound calls are getting a 403 error (ccsip messages and ccapi inout debugs attached). It seems that Verizon are rejecting the call because of an unknown source IP address. The correct dial peer is being matched (config attached) and media/control signalling is bound under the dial peers.

I tried editing a few things on the SIP headers but it didn't make any difference. Can anyone see what's wrong on this?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
j.huizinga
Frequent Contributor

OK, then bind it to 172.16.10.89

View solution in original post

7 REPLIES 7
j.huizinga
Frequent Contributor

Don't think Verizon likes your IP: 10.10.10.31, which makes sense because it is a private IP

You have to talk with Verizon if they want to see some specific IP, or any real IP will do. It all depends on the provider

Bye

Hi,

thanks for the response. I was guessing that they want to see 172.16.10.89 which is their EBI (enterprise border interface). I tried sending that in the message but it didn't seem to send.

j.huizinga
Frequent Contributor

OK, then bind it to 172.16.10.89

View solution in original post

So the way I've configured the external interface is

interface GigabitEthernet0/0/2
 ip address 172.16.10.91 255.255.255.248
 negotiation auto
 redundancy rii 2
 redundancy group 1 ip 172.16.10.89 exclusive

I have this interface bound to the outbound dial peers

In the debugs I see 172.16.10.91 rather than 172.16.10.89. I can't seem to force the .89 though.

Got it working. The redundancy group command hadn't taken. 2 reboots.........working fine.

j.huizinga
Frequent Contributor

And maybe you should remove "header-passing"

The inward dial-peers are bound to 0/0/1 and the outbound dial-peers are bound to 172.16.10.89

To check do "debug ccsip messages"

j.huizinga
Frequent Contributor

Or as an alternative you can bind all to 172.16.10.89, just make sure that the CUCM routes to gig 0/0/1 to get to 172.16.10.89

Content for Community-Ad

Spotlight Awards 2021